Skip to content

Made in Poland, delivered across the EU.Check the price of your part

Our print farm: Bambu Lab X2D printers

Every part we make is printed on a Bambu Lab X2D. All machines are the same model, so the settings we tune for your part give the same result on every printer in the farm.

Bambu Lab X2D 3D printer with the AMS 2 multi-material system
Printers
Bambu Lab X2D only
Build volume
256 × 256 × 260 mm
Toolhead
two hardened steel nozzles
Chamber
actively heated to 65 °C

Why one printer model

In batch work, repeatability is what counts. When every machine is identical, a print profile prepared and proven for your part runs the same way on all of them. We split the batch across printers and print in parallel, and parts from different machines do not differ in dimensions or appearance.

Bambu Lab X2D specification

ParameterValue
ProcessFDM
Build volume, one nozzle256 × 256 × 260 mm
Build volume, two nozzles235.5 × 256 × 256 mm
Nozzlestwo, hardened steel, 0.2–0.8 mm diameter
Max. nozzle temperature300 °C
Max. bed temperature120 °C
Chamberactively heated, up to 65 °C
Speed and accelerationup to 1000 mm/s, up to 20,000 mm/s²
Air filtrationG3 pre-filter, HEPA H12, activated carbon
Process monitoringoverview and toolhead cameras, filament run-out and tangle sensors, resume after power loss

Printer manufacturer's data.

What it means for your order

  • Parts up to 256 × 256 × 260 mm are printed in one piece. Larger ones are split into segments joined after printing.
  • The heated chamber keeps the temperature around the part steady, which limits shrinkage and warping in ABS and ASA.
  • The second nozzle prints supports in a different material: they come off more easily and leave a cleaner surface underneath.
  • Hardened steel nozzles handle plastics filled with carbon or glass fibre, available on request.
  • Cameras and sensors watch each print and stop it at the first fault, instead of wasting material on the whole batch.

Quality control across the batch

  1. Before the batch we print a first article and measure the critical dimensions from your drawing or job description.
  2. Once you approve it, the print profile is saved and used on every printer that makes your batch.
  3. During production we spot-check dimensions and appearance on parts from different machines.
  4. Before dispatch we look over every part and pack the batch so that parts do not knock against each other in transit.

Machine maintenance

Repeatability depends not only on the printer model but also on its condition. We replace hardened nozzles as they wear, clean and lubricate the guides at fixed intervals, and degrease the PEI build plates before every job, so the first layer holds the same way on every machine.

Common questions

Can you print a part larger than the build volume?

Yes, as segments joined after printing with adhesive, screws or snap fits. We suggest where to split it in the quote, so the joint does not fall in a loaded area.

Why do you print on only one printer model?

Because repeatability decides a batch. When all machines are identical, the print profile proven for your part runs the same on each of them. The batch prints in parallel and parts from different printers are indistinguishable.

Which materials can your printers handle?

The Bambu Lab X2D has an actively heated chamber up to 65 °C, hardened steel nozzles and air filtration. That lets us print not only PETG and PLA but also ABS, ASA, nylon, flexible TPU and carbon fibre grades.

A file or just an idea? Either is enough to start.

Upload a model and see a guide price straight away, or tell us what you need. Written enquiries get a specific quote in reply.